CR2032 Coin Cell Holder Tray — 24-Cell 4×6 Flat-Lay Array
A flat-lay tray that holds 24 CR2032 coin cell batteries visible and organized in a 4×6 grid, in a count that doesn't match the fixed 10/15/17-count presets sold as ready-made holders or dispensers.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 150 mm |
| Y | 100 mm |
| Z | 7 mm |
About this model
Real CR2032 holder/dispenser listings sell fixed presets (10, 15, or 17 count). 24 falls outside all of them -- real demand for a count the existing presets don't cover.
Fit notes
- 20mm cell diameter (CR2032 standard) plus 1mm clearance
- 4mm pocket depth, slightly deeper than the 3.2mm standard CR2032 thickness so each cell sits flush/recessed
- 4×6 layout (24 cells) -- a count outside the observed 10/15/17 presets
- This is a flat-lay HOLDER tray, not a spring-loaded dispenser -- cells rest visible in shallow wells; nothing pushes them out
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- coin-cell-holder-cr2032
- Category
- holders
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /objects/coin-cell-holder-cr2032/model.stl
- STEP file
- /objects/coin-cell-holder-cr2032/model.step
Similar objects
AA Battery Holder Tray — 30-Cell 5×6 Array
A tray that holds 30 AA batteries upright and organized in a 5×6 grid, for bulk battery storage in a count that doesn't match the fixed 16/20/25-count presets sold as ready-made holders.
117×97.5×33mm
AAA Battery Holder Tray — 24-Cell 4×6 Array
A tray that holds 24 AAA batteries upright and organized in a 4×6 grid, for bulk battery storage sized exactly to AAA's own diameter rather than a generic multi-size battery organizer.
93×62×28mm
C Battery Holder Tray — 15-Cell 3×5 Array
A tray that holds 15 C-cell batteries upright and organized in a 3×5 grid, for bulk battery storage in a count that doesn't match the fixed 8/12-count presets sold as ready-made holders.
156×93.6×33mm
D Battery Holder Tray — 10-Cell 2×5 Array
A tray that holds 10 D-cell batteries upright and organized in a 2×5 grid, for bulk battery storage in a count that doesn't match the fixed 8/12-count presets sold as ready-made holders.
196×78.4×38mm