Electronics & Maker Bench
Low-voltage bench rests, reference gauges, and organizers without electrical, fit, or thermal-safety claims.
10 objects in this category
Loose Inclined Breadboard Viewing Stand
Rest a small breadboard at an incline for tabletop circuit viewing without a snap-fit or device-size promise.
78×48×29mm
Loose Caliper Measuring Pose Rest
Keep a caliper in a repeatable resting pose between measurements without constraining its jaws or claiming a model-specific fit.
104×30×8mm
Jumper Wire Length Reference Stick
Compare loose jumper leads against spaced reference notches while sorting an electronics project; it is not a calibrated measuring instrument.
120×18×3mm
Jumper Offcut Winding Mandrel
Wind loose short jumper-wire offcuts around a central post so they stay together on a maker bench; no retention or bend-radius guarantee.
42×42×29mm
Small Enclosure Label Alignment Template
Position repeated small labels by aligning a removable template window with a plain project enclosure; this is a generic layout aid, not a device-specific panel template.
80×40×2.4mm
Component Lead Spacing Gauge
Compare loose component leads against three nominal center spacings before bending; the holes are references, not a component fit guarantee.
70×16×3mm
Open PCB Edge Display Rail
Stand a bare circuit board on an open shallow edge channel while leaving its faces accessible for a tabletop demonstration.
72×16×12mm
Low-Voltage Plug End Parking Gate
Separate loose low-voltage plug ends into open width classes at a bench so they do not slide together; no connector standard or fit is claimed.
64×28×20mm
Loose Probe Tip Parking Plate
Park loose low-voltage probe tips separately on a bench between measurements; aperture sizes are generic and do not assert probe compatibility.
64×28×8mm
Open Sensor Module Demonstration Shelf
Display one small sensor module above a tabletop base with an open front and accessible sides for a live demonstration.
64×48×10mm