Open PCB Edge Display Rail
Stand a bare circuit board on an open shallow edge channel while leaving its faces accessible for a tabletop demonstration.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 72 mm |
| Y | 16 mm |
| Z | 12 mm |
About this model
Demand hypothesis only: this is a specific low-voltage maker-bench task; search demand has not yet been measured.
Fit notes
- length_mm=72 (assumed): Generic non-fit-critical design premise; validate before relying on it.
- width_mm=16 (assumed): Generic non-fit-critical design premise; validate before relying on it.
- height_mm=12 (assumed): Generic non-fit-critical design premise; validate before relying on it.
- channel_width_mm=4 (assumed): Generic non-fit-critical design premise; validate before relying on it.
- channel_depth_mm=3 (assumed): Generic non-fit-critical design premise; validate before relying on it.
- end_margin_mm=7 (assumed): Generic non-fit-critical design premise; validate before relying on it.
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested. No physical print or fit sampling was performed.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- electronics-pcb-edge-display-rail
- Category
- electronics
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /artifacts/objects/electronics-pcb-edge-display-rail/sha256/d265a3c8174f94b850401cbdefc2e545ad94b451d6038c89e4da67c313fff1f3.stl
- STEP file
- /artifacts/objects/electronics-pcb-edge-display-rail/sha256/9e2b5ebd77a8d393a48a7209e30910d4b386b1c0f2f8da6ec0ad65f770085078.step
Similar objects
Loose Inclined Breadboard Viewing Stand
Rest a small breadboard at an incline for tabletop circuit viewing without a snap-fit or device-size promise.
78×48×29mm
Loose Caliper Measuring Pose Rest
Keep a caliper in a repeatable resting pose between measurements without constraining its jaws or claiming a model-specific fit.
104×30×8mm
Jumper Wire Length Reference Stick
Compare loose jumper leads against spaced reference notches while sorting an electronics project; it is not a calibrated measuring instrument.
120×18×3mm
Jumper Offcut Winding Mandrel
Wind loose short jumper-wire offcuts around a central post so they stay together on a maker bench; no retention or bend-radius guarantee.
42×42×29mm