Raspberry Pi 4B Wall Mounting Plate — 58×49mm Hole Pattern
A flat wall-mounting plate with 4 holes at the Raspberry Pi 4 Model B's official mounting hole spacing (58×49mm, 2.7mm diameter for M2.5 screws), for screwing a Pi board directly to a wall or panel.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 80 mm |
| Y | 70 mm |
| Z | 4 mm |
About this model
Real, recurring demand for Raspberry Pi wall/panel mounts across Etsy and Printables. The Pi 4B's mounting hole pattern is officially documented (four holes at the corners of a 58mm x 49mm rectangle, 2.7mm diameter, per the Raspberry Pi Foundation's mechanical drawing), so this plate is built to the exact published spec rather than a guessed hole pattern.
Fit notes
- 80x70mm plate footprint -- margin around the 58x49mm hole spacing for a stable mounting surface
- 4mm plate thickness -- rigid enough for a wall-mounted board, not fit-critical
- Hole positions/diameter taken directly from the Raspberry Pi 4B official mechanical spec (58x49mm spacing, 2.7mm diameter, M2.5), not assumed
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- rpi4-wall-mount-plate
- Category
- mounts
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /objects/rpi4-wall-mount-plate/model.stl
- STEP file
- /objects/rpi4-wall-mount-plate/model.step
Similar objects
2.5in SSD/HDD Mounting Plate — SFF-8201 Hole Pattern
A flat mounting plate with 4 holes at the official SFF-8201 side-hole spacing for a 2.5in SATA drive, for screwing an SSD or HDD directly to a chassis, DIN rail bracket, or custom enclosure.
80×95×3mm
VESA 100×100 Mounting Plate — Official Hole Pattern
A flat adapter plate with 4 holes at the official VESA MIS-D 100×100mm hole spacing, for mounting a monitor/panel-compatible device to any VESA-standard arm or bracket.
120×120×5mm