Open-front paper filter sleeve stand
A rear stop and two low side rails support a packaged paper-filter sleeve above a flat base.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 112 mm |
| Y | 78 mm |
| Z | 66 mm |
About this model
Hypothesis: coffee-filter packages benefit from a defined countertop storage place; no specific package measurement or request was collected.
Fit notes
- The stand is open at the front and top.
- No named package fit or food-contact certification is claimed.
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested. No physical print or fit sample was performed.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- kitchen-coffee-filter-sleeve-stand
- Category
- kitchen
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /artifacts/objects/kitchen-coffee-filter-sleeve-stand/sha256/a52037655e8177bd65ead9be4a11e9c31987e340e73a1bd9361614fcebd12619.stl
- STEP file
- /artifacts/objects/kitchen-coffee-filter-sleeve-stand/sha256/a8f387fa8b8a5109de530731d52f0831d39d138aeca774973e4fa21828442966.step
Similar objects
Four-lane coaster airing rack
Four raised parallel rails and end bars keep coasters separated in an open rack.
102×84×28mm
Countertop cleaning-cloth airing rail
Two feet and upright masts support one horizontal open rail for a cleaning cloth.
126×56×78mm
Three-post reusable bag loop keeper
Three separated round posts provide loose-loop parking points on a low base.
104×46×26mm
Loose utility-roll cradle
A base with two triangular end supports holds a loose roll above the surface.
136×52×39mm