Loose wire-spool tail clip
Keeps the free end of craft or low-voltage hookup wire near a spool between uses.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 22 mm |
| Y | 2.4 mm |
| Z | 11 mm |
About this model
Use-case hypothesis for loose wire-end tidiness; clip force and long-term retention are untested.
Fit notes
- Loose-use, non-load-bearing accessory; no mounting, safety, precision fit, food contact or liquid-flow guarantee.
- Physical fit and material-specific performance are untested.
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested. No physical print or handling test was performed.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- workshop-wire-spool-tail-clip
- Category
- workshop
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /artifacts/objects/workshop-wire-spool-tail-clip/sha256/623453da2d5d40110d8b7c8dc99ac53be5a650c0a5eefba305dce97d6c5833ad.stl
- STEP file
- /artifacts/objects/workshop-wire-spool-tail-clip/sha256/0be48415075d8e88a42393a78d58321198db613cb00b6aa4114d90f804981d47.step
Similar objects
Four-bay open bench locator
Separates loose hand tools or work-in-progress parts into four open staging lanes.
72×54×4.8mm
Open bench transfer chute
Moves dry small parts between adjacent trays along an open guided channel.
36×90.05×12mm
Six-channel open cable comb
Separates loose low-voltage patch and charging leads on a bench.
72×51×9mm
Wide-channel desk cable comb
Separates three thicker desk leads at a shared work position.
64×46×9.25mm