Single-slot vertical board storage spacer
A base and two parallel cheeks form one nominal open-ended storage slot.
✓ Full requirement coverage✓ Digitally validated
Key dimensions
| X | 104 mm |
| Y | 72 mm |
| Z | 27 mm |
About this model
Hypothesis: compact kitchens need a freestanding single-slot spacer for one board; no specific request or board measurement was collected.
Fit notes
- Slot width is a nominal design premise, not a fit claim.
- Stability, board fit, and food-contact suitability are untested.
Printing & use notes
No print settings (layer height, infill, supports) are specified for this model — use standard settings for your printer and material. See the validation section below for what has and hasn't been checked.
Validation
Requirement coverage
Full — this model covers the stated requirement completely.
LOW RISK Low risk — simple geometry, loose clearances, not load-bearing.
Digitally validated
- ✓ Geometry valid
- ✓ Matches stated dimensions/spec
- ✓ Manifold (watertight)
- ✓ Slicer compatible
- External manufacturing preflight: not checked
Physical fit and print performance
Physical fit and material/printer-specific performance are not independently guaranteed unless explicitly stated. Physical validation status for this object: not yet physically tested. No physical print or fit sample was performed.
MyMakerPilot does not guarantee shrinkage, warping, layer adhesion, strength, real-world load bearing, printer-specific tolerance, or first-print functional usability. Physical printing is optional calibration/sampling, not a publishing requirement.
Technical details
Internal provenance and file references, for anyone who wants the full picture.
- Object ID
- kitchen-vertical-board-slot
- Category
- kitchen
- Risk classification
- low
- External preflight
- unknown
- Physical validation
- unknown
- Production cost
- unknown
- Human review time
- unknown
- STL file
- /artifacts/objects/kitchen-vertical-board-slot/sha256/521cb2e3369b0dd50a8bb10b952cb1e9216f7b79854d7d6265e98ae1a0febf01.stl
- STEP file
- /artifacts/objects/kitchen-vertical-board-slot/sha256/7a76ec4d0d1aa23bc8352e155546dfec5c1372f007121d1d335f2123e757b755.step
Similar objects
Four-lane coaster airing rack
Four raised parallel rails and end bars keep coasters separated in an open rack.
102×84×28mm
Open-front paper filter sleeve stand
A rear stop and two low side rails support a packaged paper-filter sleeve above a flat base.
112×78×66mm
Countertop cleaning-cloth airing rail
Two feet and upright masts support one horizontal open rail for a cleaning cloth.
126×56×78mm
Three-post reusable bag loop keeper
Three separated round posts provide loose-loop parking points on a low base.
104×46×26mm